T-Molding
No cabinet restore is complete without new molding. This cabinet featured black 3/4” round molding with textured “leathering” that is so common I keep it in stock.
Many portions of the channel that vertical part of the “T” in T-Molding were destroyed. The Bondo makes a good replacement for strength but often the channel is filled in by the Bondo application. I found a router bit that opens (re-cuts) the channel and got to work.
The is is a nicely styled cabinet that includes several turns for the molding. You have to measure, cut and apply the molding in a rough estimate fashion then make the breaks and wedges in the grip (vertical part of the T) to accommodate smooth application around the curves.
I like to apply small amounts of Expanding Glue (like Gorilla brand) in the control panel sides and bottoms just to ensure a tighter fit/grip where the most wear occurs. Keep it light! adjustment may be needed and eventual replacement will happen. If you stuff the channel with Gorilla Glue you will regret it at replacement time and it often oozes out and looks plain ugly to me.
Many portions of the channel that vertical part of the “T” in T-Molding were destroyed. The Bondo makes a good replacement for strength but often the channel is filled in by the Bondo application. I found a router bit that opens (re-cuts) the channel and got to work.
The is is a nicely styled cabinet that includes several turns for the molding. You have to measure, cut and apply the molding in a rough estimate fashion then make the breaks and wedges in the grip (vertical part of the T) to accommodate smooth application around the curves.
I like to apply small amounts of Expanding Glue (like Gorilla brand) in the control panel sides and bottoms just to ensure a tighter fit/grip where the most wear occurs. Keep it light! adjustment may be needed and eventual replacement will happen. If you stuff the channel with Gorilla Glue you will regret it at replacement time and it often oozes out and looks plain ugly to me.
Artwork Applied
Artwork is finally applied. These are very large artwork pieces and required so much in the patience department. We masked off 1” along the back and top to ensure proper alignment. It worked out pretty well. I think the reproduction artwork is about 2” shorter than the original. The top, back and front look great but the part that fills the control panel sides looks a little higher than I would like. But much better than missing, torn or faded art.
Photos: Artwork
Photos: Artwork
Repair the Damage
After months of moving this cabinet without the base to keep it off the concrete floor some damage was inflicted on the bottom edges. Now that the base is built we can repair it. That’s right, more Bondo.
Photos: Bondo and Paint
Photos: Bondo and Paint
Star Base
This cabinet had a serious rotted base that had to go. We built a new, lighter base and installed the missing levelers. There was no progress on this project for months while I worked out the ventilation, air pressure situation and general overspray protection.
Paint, the Final Frontier
Started to use the paint booth today. Mike will be happy I am making progress on his Start Trek paint. One side is done, may get one last coat but it looks pretty good. Back is done just need to peel away the masks when dry. Third side was just one coat, then I ran dry.
Photos: Paint